TROUBLESHOOTING CLASSIFICATION AND PROCEDURES OF TROUBLESHOOTING Phenomena supposed to be Failures and Troubleshooting No. 20-314 D85EX-15 (1) No. Phenomenon suppose to be Failure Troubleshooting Error Code E Mode H Mode S Mode Phenomenon related to action code/error code 1 An action code is displayed on the monitor panel. Check the error code. 2 A error code is displayed in the error code display mode. q Phenomenon related to engine 3 The engine does not start smoothly. (Engine starting takes a time all the time.) S-1 4 The engine does not start. The engine does not rotate. E-1 S-2a) 5 The engine rotates but does not exhaust gas. S-2b) 6 The engine exhausts gas but does not rotate.
S-2c) 7 The engine does not pick-up smoothly. (Poor follow-up performance) S-3 8 The engine stops during operation. S-4 9 The engine rotates abnormally. (Hunting) S-5 10 Insufficient output or no power S-6 11 Black exhaust (Imperfect combustion) S-7 12 Large oil consumption or blue exhaust S-8 13 Oil is contaminated fast. S-9 14 Large fuel consumption S-10 15 Oil mixes in coolant, spurts or water reduces. S-11 16 Engine oil pressure drops. S-12 17 Oil increases. S-13 18 Water temperature rises too high. (Overheat) S-14 19 An abnormal noise occurs. S-15 20 Large vibration S-16 21 The preheater does not work.
E-2 Phenomenon related to power train 22 The power train has no power (no drawbar pull). H-1 S-6 23 The power train does not travel (in case of 2-spool or 3-spool). H-2 24 The power train does not start at all gear speeds. H-3 25 The power train travel forward or in reverse only H-4 26 Large time lag at any gear speed or at forward-reverse shifting H-5 27 Steering is not possible. (Left turn or right turn is impossible.) H-6 28 The steering speed is slow or the steering system has no power. H-7 29 The brake does not work. H-8 30 The power train oil is overheated.
H-9 31 Abnormal noise around the HSS and work equipment pump or the HSS motor H-10 Phenomenon related to work equipment 32 All the work equipment operates slowly. H-11 33 All the work equipment does not operate. H-12 34 The blade lift moves slowly or has no power. H-13 35 The blade tilt moves slowly or has no power. H-14 36 The ripper lift moves slowly or has no power. H-15 37 Large hydraulic drift of the blade lift H-16 38 Large hydraulic drift of the blade tilt H-17 39 Large hydraulic drift of the ripper lift H-18