TROUBLESHOOTING ERROR CODE 15SBLH ERROR CODE 15SBLH (REVERSE CLUTCH: SEE THE LIST. (LH)) Circuit diagram related to transmission reverse clutch ECM D85EX-15 20-411 (1) Action co de Error code Controller code R Trouble ( everse clutch: See the list. (LH) Steering and transmission controller system) CALL E0 3 15SBLH Steering and transmission Contents trouble of • The fill switch signal is not set on at output to the transmission reverse clutch solenoid circuit. Action o controlle • Flashes caution lamp and turns on caution buzzer. f • Decides that engine speed is neutral (N) at reverse operation. r • Limits operation of engine and transmission.
Problem t appears machin hat • Once machine is stopped, engine speed is limited to medium (half). on • Once machine is stopped, running is limited to F1. e Related informati • The input state (ON/OFF) from the reverse clutch fill switch can be checked in monitoring mode. (Code 31520: Transmission fill switch input state) on • Method of reproducing error code:
Engine start + Forward running Possible ca and standar value in nor state Cause Defective reverse clutch fill 1 switch (Internal short) Disconnection in wiring har- uses ness (Disconnection in wir- 2 d ing or defective contact in mal connector) Defective steering and 3 transmission controller Defective hydraulic pres- 4 sure system i Standard value in normal state/Remarks on troubleshooting Defective reverse clutch fill switch (Internal short) aPrepare with starting switch OFF, then start the engine for trouble- shooting. FRT (male) PCCS lever Resistance Between (1) – chassis ground N Min. 1Mz R (Reverse) Max.
1z Disconnection in wiring har- ness (Disconnection in wir- ing or defective contact in connector) aPrepare with starting switch OFF, then carry out troubleshooting without turning starting switch ON. Wiring harness between STC2 (female) (25) – FRT (female) (1) Resistance Max. 1Mz Defective steering and transmission controller aPrepare with starting switch OFF, then start the engine for trouble- shooting. STC2 PCCS lever Voltage Between (25) – chassis ground N 20 – 30V R (Reverse) Max. 1V Defective hydraulic pres- sure system i When no fault is detected in the electric system, the hydraulic pressure system is assumed to be abnormal. Carry out the related troubleshoot- ng (H mode).