TROUBLESHOOTING ERROR CODE DXH4KA ERROR CODE DXH4KA (1ST CLUTCH ECMV: DISCONNECTION (KA)) Circuit diagram related to transmission 1st clutch ECMV 20-544 D85EX-15 (1) Action code Error code C ontroller code Trouble 1st clutch ECMV: Disconnection (KA) (Steering and transmission controller system) CALL E03 DXH4KA Steering and transmission Contents of • trouble When signal is output to 1st clutch solenoid circuit, any current does not flow. • Action of • controller • Flashes caution lamp and turns on caution buzzer. Stops outputting to transmission 1st clutch solenoid circuit. Limits operation of engine and transmission.
Problem that • appears on • machine • Automatic shift-down function does not work. Once machine is stopped, engine speed is limited to medium (half). Once machine is stopped, travel is limited to F2 and R2. • Related information • Output (Current) to 1st clutch solenoid can be checked in monitoring mode. (Code 31602, 31612: Output current of 1st clutch ECMV) Method of reproducing service code: Start engine and drive machine in F1 or R1.
Possible causes and standard value in normal state Cause Standard value in normal state/Remarks on troubleshooting Defective 1st clutch ECMV 1 (Internal short circuit) aPrepare with starting switch OFF, then carry out troubleshooting without turning starting switch ON. S1T (male) Resistance Between (1) – (2) 5 – 25z Disconnection in wiring har- ness (Disconnection in wir- 2 ing or defective contact in connector) aPrepare with starting switch OFF, then carry out troubleshooting without turning starting switch ON. Wiring harness between STC3 (female) (6) – S1T (female) (1) Resistance M ax. 1z Wiring harness between STC3 (female) (23) – S1T (female) (2) Resistance M ax.
1z Short circuit with power 3 source in wiring harness (Contact with 24V circuit) aPrepare with starting switch OFF, then turn starting switch ON and carry out troubleshooting. Short circuit of wiring harness between STC3 (female) (6) – S1T (female) (1) with chassis ground Voltage M ax. 1V Defective steering and 4 transmission controller aPrepare with starting switch OFF, then carry out troubleshooting without turning starting switch ON. STC3 (female) Resistance Between (6) – (23) 5 – 25z