TROUBLESHOOTING E-26 20-658 D85EX-15 (1) Trouble (2) • Cooling is not possible. Related information Possible causes and standard value in normal state Cause Standard value in normal state/Remarks on troubleshooting 1 Defective pressure switch H Prepare with the starting switch OFF, then turn the starting switch ON and carry out troubleshooting. CN-P Blower switch Voltage Between (6B) and ground ON 20 – 30V 2 Defective compressor clutch relay (coil side) aPrepare with the starting switch OFF, then carry out troubleshooting without turning the starting switch ON.
CN-R5 (male) Resistance Between (1) and (2) 240 ± 40z 3 Defective compressor clutch relay (contact side) aPrepare with the starting switch OFF, then turn the starting switch ON and carry out troubleshooting. CN-R5 Voltage Between (18A) and ground 20 – 30V 4 Defective condenser relay (contact side) aPrepare with the starting switch OFF, then turn the starting switch ON and carry out troubleshooting. CN-R6 Voltage Between (23A) and ground 20 – 30V 5 Defective thermistor aPrepare with the starting switch OFF, then carry out troubleshooting without turning the starting switch ON. AC1 (male) Resistance Between (9A) and (13A) Max.
3,500z 6 Defective condenser blower resistor aPrepare with the starting switch OFF, then carry out troubleshooting without turning the starting switch ON. Condenser blower resistor Resistance Between terminals 2.8z ± 5% 7 Defective condenser motor aTurn the starting switch on and carry out the troubleshooting. The motor is in order if it is rotating when the air conditioner is switched ON. 8 Defective compressor mag- net clutch aStart the engine and carry out the troubleshooting. The compressor magnet clutch is supposed to be out of order, so in- spect it directly. 9 Defective compressor aStart the engine and carry out the troubleshooting.
The compressor is supposed to be out of order, so inspect it directly. 10 Disconnection of wiring har- ness (Disconnection in wir- ing or defective contact in connector) aPrepare with the starting switch OFF, then carry out troubleshooting without turning the starting switch ON. Wiring harness between CB2 outlet and CN-R6 (female) (8B) or CN-R5 (female) (8D) or CN-R1 (female) (8C) Resistance Max. 1z Wiring harness between CN-R5 (female) (18A) and A/C (female) (1) Resistance Max. 1z Wiring harness between CB2 outlet and CN-R5 (female) (1K) Resistance Max. 1z Wiring harness between CN-T (female) (9B) and AC1 (female) (9A) Resistance Max. 1z