TROUBLESHOOTING H-12, H-13 H-12 WORK EQUIPMENT DOES NOT MOVE H-13 BLADE LIFT SPEED IS SLOW OR LACKS POWER D85EX-15 20-711 (1) Trouble • Work equipment does not move. Related information • Confirm that the oil quantity of the hydraulic oil tank is normal before troubleshooting. Possible causes and standard value in normal state Cause Standard value in normal state/Remarks on troubleshooting 1 Defective PTO (Pump drive unit of HSS and work equip- ment) The PTO pump drive unit of the HSS and work equipment is assumed to be defective; directly check it. 2 Defective HSS and work equipment pump The HSS and work equipment pump is assumed to be defective; di- rectly check it.
3 Defective unload valve function aPrepare with starting switch OFF, then drive the engine in high idling mode for troubleshooting. Work equipment lever Unload pressure Full neutral 2.45 – 3.82MPa {25 – 39kg/cm2} 4 Defective set pressure or defective function of main relief valve aPrepare with starting switch OFF, then drive the engine in high idling mode for troubleshooting. Work equipment lever Main relief pressure Stroke end 22.54 ± 1.18MPa {230 ± 12kg/cm2} 5 Defective function of self- pressure reducing valve (PPC original pressure) aPrepare with starting switch OFF, then drive the engine in high idling mode for troubleshooting.
Work equipment lever Original pressure of control circuit Full neutral 3.77 – 4.46MPa {38.5 – 45.5kg/cm2} Trouble • Blade lift speed is slow or lacks power. Related information • Confirm that the oil quantity of the hydraulic oil tank is normal before troubleshooting. • Confirm whether the blade is remodeled. • When the hydraulic drift rate of the blade lift is also high, carry out troubleshooting “High Hydraulic Drift Rate of Blade Lift.” Possible causes and standard value in normal state Cause Standard value in normal state/Remarks on troubleshooting 1 Defective PPC valve func- tion aPrepare with starting switch OFF, then drive the engine in high idling mode for troubleshooting.
Blade lever PPC valve output pressure Lift stroke end 3.82 – 4.12MPa {39 – 42kg/cm2} 2 Defective function of blade lift operation valve (Spool) The spool function of the blade lift operation valve is assumed to be de- fective; directly check it. 3 Aired blade lift cylinder The blade lift cylinder is assumed to be aired; carry out the air bleed and observe how the phenomenon changes.