TROUBLESHOOTING H-14, H-15 H-14 BLADE TILT SPEED IS SLOW OR LACKS POWER H-15 RIPPER LIFT SPEED IS SLOW OR LACKS POWER 20-712 D85EX-15 (1) Trouble • Blade tilt speed is slow or lacks power. Related information • Confirm that the oil quantity of the hydraulic oil tank is normal before troubleshooting. • Confirm whether the blade is remodeled.
• When the hydraulic drift rate of the blade tilt is also high, carry out troubleshooting “High Hydraulic Drift Rate of Blade Tilt.” Possible causes and standard value in normal state Cause Standard value in normal state/Remarks on troubleshooting 1 Defective PPC valve func- tion aPrepare with starting switch OFF, then drive the engine in high idling mode for troubleshooting. Blade lever PPC valve output pressure Lift stroke end 3.82 – 4.12MPa {39 – 42kg/cm2} 2 Defective function of blade tilt operation valve (Spool) The spool function of the blade tilt operation valve is assumed to be de- fective; directly check it.
3 Aired blade tilt cylinder The blade tilt cylinder is assumed to be aired; carry out the air bleed and observe how the phenomenon changes. Trouble • Ripper lift speed is slow or lacks power. Related information • Confirm that the oil quantity of the hydraulic oil tank is normal before troubleshooting. • Confirm whether the ripper is remodeled.
• When the hydraulic drift rate of the ripper lift is also high, carry out troubleshooting “High Hydraulic Drift Rate of Ripper Lift.” Possible causes and standard value in normal state Cause Standard value in normal state/Remarks on troubleshooting 1 Defective PPC valve func- tion aPrepare with starting switch OFF, then drive the engine in high idling mode for troubleshooting. Ripper lever PPC valve output pressure Lift stroke end 3.82 – 4.12MPa {39 – 42kg/cm2} 2 Defective function of ripper lift operation valve (Spool) The spool function of the ripper lift operation valve is assumed to be defective; directly check it.
3 Defective function of ripper lift operation valve (suction valve) The suction valve of the ripper lift operation valve is assumed to be de- fective; directly check it. aReplace the suction valve in the head with one at the bottom, and observe how the phenomenon changes. 4 Aired ripper lift cylinder The ripper lift cylinder is assumed to be aired; carry out the air bleed and observe how the phenomenon changes.