Komatsu — INSTALLATION

DISASSEMBLY AND ASSEMBLY ENGINE CYLINDER HEAD [*10] Tighten the exhaust manifold assembly mount- ing bolts in the order shown below, and then tighten the other bolts. [*23] 3 Wiring harness capture nut: 2.0 – 2.4 Nm {0.2 – 0.24 kgm} 3 Exhaust manifold assembly mounting bolt: 58.8 – 73.5 Nm {6 – 7.5 kgm} [*24] 3 Rocker shaft mounting bolt: 58.8 – 73.5 Nm {6 – 7.5 kgm} a For the procedure for adjusting the valve clearance, see TESTING AND ADJUSTING, Adjusting valve clearance. [*25] a For the procedure for installing the injector and nozzle holder, see REMOVAL, INSTAL- LATION OF NOZZLE HOLDER ASSEMBLY. [*26] 3 Rocker housing mounting bolt:

58.8 – 73.5 Nm {6 – 7.5 kgm} [*11] [*12] [*27] a Clean the underside of the head, top of the block, and liners with dry cloth or cloth soaked with solvent. a Tighten each bolt into the block with the fin- gers at least 2 turns. 3 Cooling tube connecting hose clamp: 4.4 ± 0.49 Nm {0.45 ± 0.5 kgm} [*13] [*14] [*17] [*18] [*19] [*21] a For the procedure for tightening the high- pressure pipe, see REMOVAL, INSTALLA- TION OF NOZZLE HOLDER ASSEMBLY. 2 Threads of bolt and underside of bolt head: LM-P or engine oil (E030-CD) a Tighten the cylinder head mounting bolts in the order shown below. [*15] Tighten the air intake manifold assembly mount- ing bolts in the order shown below.

3 Cylinder head mounting bolts 1 – 6: 1st time: 88.3 – 108 Nm {9 – 11 kgm} 2nd time: 157 – 167 Nm {16 – 17 kgm} 3rd time: 1) When using tool A4 Using tool A4 , retighten each bolt by 90° in the order of 1 – 6. +30° 0 [*16] Length of spacer: L = 45.8 mm (2 pieces) [*20] 3 Spill tube: 9.8 – 12.7 Nm {1.0 – 1.3 kgm} [*22] 3 Head cover mounting bolt: 1.0 ± 0.1 Nm {15 ± 1 kgm} 30-34 D85EX-15 (2)