DISASSEMBLY AND ASSEMBLY ENGINE CYLINDER HEAD 2) When not using tool A4 Make marks on the all bolts and cylinder head with a marker, then retighten each bolt by 90° in the order of 1 – 6. a After tightening bolts 1 – 6, tighten auxiliary bolt 7. +30° 0 3 Cylinder head auxiliary mounting bolt 7: 66.2 ± 7.4 Nm {6.8 ± 0.8 kgm} Refilling with water Add water through the water filler to the specified level. Run the engine to circulate the water through the system. Then, check the water level again. 5 Cooling water: Approx. 80 l D85EX-15 30-35 (2)