Komatsu — REMOVAL AND INSTALLATION

DISASSEMBLY AND ASSEMBLY TRACK ROLLER REMOVAL AND INSTALLATION OF TRACK ROLLER ASSEMBLY REMOVAL 8. Remove the mounting bolts of track roller assembly (8). 1. Loosen the track shoe assembly. For details, see EXPANDING TRACK SHOE ASSEMBLY. 2. Remove 2 retainers (1) in the track frame and the 5 nuts of guard tension bolts (2). [*1] 3. Remove the 5 mounting bolts and track roller guard (3). [*2] 4. Remove the mounting bolts and rear roller guard (4). [*3] 9. Start the engine and raise the chassis by operat- ing the blade or ripper or by using a hydraulic jack and leave the track roller assembly on the track link.

k When raising the chassis, be sure to apply the brake and lock the work equipment con- trol lever. After raising the chassis, set a block on the track link to prevent danger. 10. Pull out and remove controller assembly (8). a Take care of the key on the inside. 5. Remove guard tension bolt (2). a Take care of the guide spacer on the inside. 4 Track roller assembly: Single flange; 72 kg Double flange; 80 kg 6. Remove 2 retainers (5) on the outside of the track frame, and then remove the 5 mounting bolts and track roller guard (6). [*4] 7. Remove the mounting bolts and rear roller guard (7). [*5] INSTALLATION Carry out installation in the reverse order to removal.

a Install the track roller assembly with the oil filler plug on the outside of the chassis. [*1] [*2] [*3] [*4] [*5] 3 Mounting bolt: 471 – 829 Nm {48 – 84.5 kgm} Adjust the track shoe assembly tension. For details, see ADJUSTING TRACK SHOE ASSEMBLY TENSION. D85EX-15 30-139 (2)