DISASSEMBLY AND ASSEMBLY CARRIER ROLLER ASSEMBLY a Clean the all parts and check them for dirt or damage before installing. 1. Using push tool [6], press fit bearing inner race (9) to shaft (11). 2. Using push tool [7], press fit bearing outer race (7) to carrier roller (6). 7. Install the O-ring and cover (2). 3. Set carrier roller (6) and bearing inner race (9) to shaft (11). 4. Using push tool [8], press fit bearing inner race (9). 8. Using tool N1 , install floating seal (10) to collar (8). a Clean and degrease the O-ring and O-ring fitting surfaces thoroughly and dry them before installing. a After installing the floating seal, check that its slant is less than 1 mm. 9.
Fit the O-ring to collar (8) and install them to car- rier roller (6), matching them to the dowel pin. a Take care not to damage the O-ring. 5. Using tool [2], tighten nut (4). 3 Nut: 98 Nm {10 kgm} a After nut (4) is tightened, if its hole is not matched to the hole on the shaft side, loosen it until the holes are aligned. 6. Install ring (3). a Check that the end play (clearance between the bearing and nut) is 0 – 0.22 mm. D85EX-15 30-145 (2)