DISASSEMBLY AND ASSEMBLY TRACK SHOE 2. Loosen the track shoe. [*1] k Do not loosen lubricator (2) more than 1 turn. a If the track shoe is not loosened after the lubricator is loosened, move the machine for- ward and in reverse. EXPANSION OF TRACK SHOE ASSEMBLY (When track frame has internal trouble) a If any abnormality is detected by Check before expanding track shoe assembly, perform the fol- lowing procedure. k If the track shoe is removed while the track frame has an internal trouble, it may spring back. Even if the track shoe is removed, the idler may jump out, and that can cause a seri- ous result. Accordingly, expand the track shoe according to the following procedure. 1.
Loosen the track shoe. [*1] k Do not loosen lubricator (2) more than 1 turn. a If the track shoe is not loosened after the lubricator is loosened, move the machine for- ward and in reverse. a Check that the all grease has been dis- charged. 3. Remove track shoe (6). [*2] a Loosen the 4 bolts by 1 – 2 turns each and check that they rotate lightly, and then pull them out. Do not pull them out one by one without checking their looseness. a If the bolts are loosened forcibly while they are still tight, the threads of them and master link (3) may be damaged. 2.
Move the machine slowly forward against large block [1] or a wall (or the blade of another machine of the similar size of the machine to be repaired, if available) to press the track shoe on the idler side. When the recoil spring and track shoe are distorted, stop and apply the brake. At this time, set the master link between the idler and front carrier roller. a For safe work, apply lever block [2] between the carrier roller support and link. 4. Sling the front end of the master link and move the machine slowly forward and in reverse to expand track shoe assembly (7). a Length of track shoe: Approx. 10.5 m 30-148 D85EX-15 (2)