DISASSEMBLY AND ASSEMBLY TRACK SHOE 3. Remove idler guide (10). a Be sure to remove the idler guide at this time. If the track shoe is expanded without removing the idler guide, the idler guide moves forward and is pressed against the track frame. If the idler guide is removed at this time, the idler yoke assembly will jump forward. INSTALLATION Carry out installation in the reverse order to expansion (ordinary). [*1] a Adjust the track shoe tension. For details, see TESTING AND ADJUSTING, Testing and adjusting track shoe tension. [*2] a Tighten the shoe mounting bolts for the mas- ter link in the following order. 2 Shoe bolt:
Lubricant containing molybdenum disulfide (LM-P ) 3 Shoe bolt (Regular link): Single shoe: Initial torque: 343 ± 39 Nm {35 ± 4 kgm} Retightening angle: 180° Swamp shoe: Initial torque: 490 ± 49 Nm {50 ± 5 kgm} Retightening angle: 180° a Tighten the all 4 bolts with fingers until the master link mating faces are fitted. a If the bolts are tightened forcibly before the master link mating faces are fitted, the threads of them and master link may be damaged. 0 - 20 0 - 20 4. Remove track shoe (6) and disconnect master link (3). [*2] a Loosen the 4 bolts by 1 – 2 turns each and check that they rotate lightly, and then pull them out. 5.
Move the machine slowly in reverse to expand track shoe assembly (7). D85EX-15 30-149 (2)