DISASSEMBLY AND ASSEMBLY TRACK SHOE a Using tool R1 , drive the small plug of the pin inward after the disassembly work so that the workplace will not become dirty. 4) Return the right cylinder and take out the links, pins, bushings, and spacers on both sides and feed the next 1 set of the link assembly to the jaw. a If the bushing ends and sealing surfaces are damaged, oil will leak. Accordingly, handle them carefully. 2) Operate the left cylinder to pull out the pin and bushing from the left link simultaneously. a Check the pulling out force of the pin and bushing to see if press fitting force for them necessary for reversed reassembly is obtained. 3.
Inspection Check the parts for the following items to see if they can be used for a lubricated track or a grease-filled track, then examine them generally and determine to use them for a lubricated track or grease-filled track. a For judgment of reuse of the parts, see "Parts judgment guide, Undercarriage, Lubri- cated track". 1) Check the parts visually for damage. If a part seems to be damaged, check it by dye pene- trant test or magnaflux inspection. If it has any crack, it cannot be used again. Discard it. 3) Return the left cylinder and operate the right cylinder to pull out the pin and bushing from the right link simultaneously. D85EX-15 30-151 (2)