DISASSEMBLY AND ASSEMBLY TRACK SHOE 2) Measure the outside diameter of the press fitting parts of the pin and bushing and the inside diameter of the pin and bushing fitting parts of the link with a micrometer and a cyl- inder gauge to see if the allowable fitting allowance is obtained. When using the pin, bushing, and link for a lubricated track, how- ever, secure the standard fitting allowance between the pin and link. a If the allowable fitting allowance is not obtained, replace the parts with new ones. a For the dimensional criteria, see MAIN- TENANCE STANDARD.
WHOLE ASSEMBLY a For the whole assembly of the track shoe, see "Parts judgment guide, Undercarriage, Revers- ing procedure for pin bushing". When recycling for lubricated track 1. Preparation work 1) Cleaning seal assembly Remove the seal assembly from the link and divide it into the seal ling and load ring, then clean them. a Since the seal ring (1) and load ring (2) are deteriorated easily by the cleaning liquid, clean them quickly. After cleaning them, wipe off the cleaning agent from them. a Precautions for storage 1) Store the seal without removing it from the link so that the counterbore portion will not be rusted and take care not to damage the seal lip.
2) Apply rust-preventive oil to the pin and bush- ing fitting parts, shoe mating surface, and master link mating surface of the link. 3) When storing, apply rust-preventive oil to the all surfaces of the pin, bushing, and spacer. Take care not to damage the ends of the bushing in particular. 2) When reusing the pin, chamfer its end cor- ners smoothly with a grinder. Remove the nodules sticking to the press fitting parts with the grinder, too. a If the ends are worn and sharpened, they may scuff the press fitting parts and cause oil leakage. 3) If the link, pin, bushing, and spacer are dirty, clean them. Remove the nodules sticking to the link and bushing with the grinder. 30-152 D85EX-15 (2)