DISASSEMBLY AND ASSEMBLY TRACK SHOE a Since these parts rust easily, clean them just before assembling them. a Do not polish the bushing ends. If they are polished, oil may leak. 4) If the large plug was pulled out, drive it in by using tool R5 . a In this case, clean the pin hole in advance by using tool R4 . 5) Installation of seal assembly Clean the counterbore portion d of the link carefully and push in the seal to the bottom by using tool R6 . a If oil is sticking to the counterbore portion of the link or seal assembly, the seal will turn and its sealing performance will lower. Accordingly, do not apply any oil.
When inserting the seal in the counter- bore portion, take care that oil not stick to the seal and counterbore portion. i) Insert the plug (3) through the plug inser- tion window into the guide hole. ii) Push the bar with the hand until the plug stops. iii) Push the plug with the bar to press the guide against the pin (4). iv) Drive in the bar with a hammer. a Driving distance a from pin end: 6 ± 2 mm a If the chamfered part of the pin hole has been worn, chamfer it with a small-sized grinder (grindstone tip angle: 45° – 60°) so that the plug will not be damaged. a Coat the plug with GO90 and drive it with the small diameter end ahead.
6) Adjust the dimensions of the press fitting jig of the link press to keep the projection of the pin and bushing constant and keep the installed dimensions of the seal within the standard range. a For the standard dimensions, see Dimen- sions table of press fitting jig of link press. a If the pin end (part P ) or the sides of the link (parts Q and R ) are worn, add the dimensions of the worn parts when adjusting the standard dimensions so that the projections of the pins and bush- ings on both sides will be even. D85EX-15 30-153 (2)