DISASSEMBLY AND ASSEMBLY TRACK SHOE 7) Set the right link and install the spacer to the pin. a Check that the seal surface and bushing end are free from dirt and apply oil (GO90) to them with a clean cloth or brush. a When installing the spacer, wipe it with a clean cloth. 9) Using the spacer [4] for fine adjustment, press fit the pin and bushing until the pin end is fitted to the bottom of the receiving jig. a Adjust the depth of the receiving jig hole so that the projections of the pin on both sides will be even. 10) Set the left link and install the spacer to the pin. a Apply oil similarly to the right link.
8) Set the right jig on the receiving side and the left one on the pushing side and press fit the pin and bushing simultaneously. a If the pin and bushing have play when they are press fitted, the seal may come off the link. To prevent this, press fit smoothly. If the seal comes off the link, stop press fitting and set the seal to the link correctly, then start press fitting again. a Press fitting force for pin and bushing: 274 – 363 kN {28 – 37 tons} D85EX-15 30-155 (2)