DISASSEMBLY AND ASSEMBLY TRACK SHOE 17) Assemble the master link on the pin side at last. a Check that the master links on both sides are press fitted in parallel. 3. Installation of shoe 1) Set the link assembly on the bed and install the shoe with a shoe bolt impact wrench and a torque wrench. a When reusing (reversing) the bushing, set the worn outside surface of the bush- ing on the shoe fitting side of the link (set the bushing with the worn outside sur- face up on the link press). 2 Shoe bolt: Lubricant containing molybdenum disulfide (LM-P) 3 Shoe bolt (Regular link): Single shoe: Initial torque: 343 ± 39 Nm {35 ± 4 kgm} Retightening angle: 120° ± 10° Swamp shoe: Initial torque:
784 ± 79 Nm {80 ± 8 kgm} Retightening angle: 120° ± 10° a Supply oil d to oil level a so that depth L of the hole of pin c will be in the following range when the link assembly is left with small plug side b up (with the link assem- bly on its side) for 30 minutes. Dimension L: 35 – 60 mm 16) After supplying oil, drive in the small plug into the specified position, using tool R3 . a Apply G090 around the small plug. a Drive in the small plug to the following depth. Driving depth from end: 2.5 ± 1 mm master link (2) together and set them to each other by the mating faces. 4) Place and fit shoe (3) to mating surface of the links.
5) Check that master bolt (4) can be tightened easily with the fingers, then connect the links with the master bolts. D85EX-15 30-157 (2) 2) When installing a 2-piece shoe, place th assembled 2-piece shoes on a level place i 1 line with the shoe side up. 3) Pull pin-side master link (1) and bushing-sid