DISASSEMBLY AND ASSEMBLY TRACK SHOE 2 Master bolt: Lubricant containing molybdenum disulfide (LM-P) 3 Master bolt (Master link) Single shoe: Initial torque: 343 ± 39 Nm {35 ± 4 kgm} Retightening angle: 180° Swamp shoe: Initial torque: 490 ± 49 Nm {50 ± 5 kgm} Retightening angle: 180° When recycling for grease-filled track 1. Preparation work 1) Cleaning seal assembly Remove the seal assembly from the link and divide it into the seal ling and load ring, then clean them. a Since the seal ring and load ring are deteriorated easily by the cleaning liquid, clean them quickly. After cleaning them, wipe off the cleaning agent from them. 0 - 20 0 - 20 a Tighten the bolts in the order of 1 – 4.
2) When reusing the pin, chamfer its end cor- ners carefully with a grinder so that it will be press fitted smoothly. 3) Drive in the large and small plugs by using tools R3 and R5 . i) Insert each plug through the plug inser- tion window into the guide hole. a Apply oil to the plug. ii) Push the bar with the hand until the plug stops. iii) Push the plug with the bar to press the guide against the pin. 30-158 D85EX-15 (2)