Komatsu — WHOLE ASSEMBLY

DISASSEMBLY AND ASSEMBLY TRACK SHOE iv) Drive in the bar with a hammer. a Driving distance a from pin end: Small plug: 2.5 ± 1 mm Large plug: 6.0 ± 2 mm a If the plugs were not pulled out when the shoe was disassembled, reuse them as they are. 7) Adjust the dimensions of the press fitting jig of the link press to keep the projection of the pin and bushing constant and keep the installed dimensions of the seal within the standard range. a For the standard dimensions, see Dimensions table of press fitting jig of link press.

a If the pin end (part P ) or the sides of the link (parts Q and R ) are worn, add the dimensions of the worn parts when adjusting the standard dimensions so that the projections of the pins and bush- ings on both sides will be even. 4) If the outside of the pin, surfaces of the spacer, and ends and inside of the bushing are dirty, clean them. 5) Apply grease to the outside of the pin and surfaces of the spacer. 6) Installation of seal assembly Clean the counterbore portion of the link carefully and push in the seal to the bottom by using tool R6 . a If grease is sticking to the counterbore portion of the link or seal assembly, the seal will turn and its sealing performance will lower.

Accordingly, do not apply any oil. 2. Assembly of link 1) Apply lithium grease (G2-LI) to the mating surfaces of the pin and bushing and assem- ble them, then set them before the jaw of the link press. a When reusing (reversing) the bushing, set the worn outside surface of the bush- ing on the shoe fitting side of the link (set the bushing with the worn outside sur- face up on the link press). D85EX-15 30-159 (2)