Komatsu — DISASSEMBLY AND ASSEMBLY OF MASTER LINK

DISASSEMBLY AND ASSEMBLY TRACK SHOE 2. Installation of link on bushing side 1) Expand the central part of the link tread with tool R2-7 as shown in the figure (Expand the link tip by 6 – 8 mm). a : 5 mm 4) Press fit pin (5) with tool R2 and install mas- ter link (1) on the bushing side. a Direct the side hole of the pin toward the link tread. 5) Install the shoe to the link at the connecting section. 6) Drive in large plug (6) with tool R5 , add oil with tool R8 , and drive in small plug (7) with R5 . a Press fit both master links in parallel (on bushing side and pin side). a Do not damage the mating faces of the master links and end of the bushing.

a The end play of the connecting section (the play of the links before and after the pin in the thrust direction) must be 0 – 0.13 mm. a Take care extremely that dirt or sand will not stick to the seal, spacer, ends of bushing, and mating face of the tapped hole. 2) Set spacer (3) and seal assembly (4) to the counterbore of the link at the connecting sec- tion. 3) Align the holes of the pin and bushing (7) and connect with guide pin R2-11 . D85EX-15 30-167 (2)