DISASSEMBLY AND ASSEMBLY TRACK SHOE 3. Installation of link on pin side 1) Set spacer (3) and seal assembly (4) to the counterbore of the master link. 2) Pass bushing (8) and pin (9), set master links (10) on the pin side from both sides, and press fit them with tool R2 . 3) Drive in large plug (11) with tool R5 , add oil with tool R8 , and drive in small plug (12) with R5 . 4. Connection of master link 1) Place the assembled 2-piece track shoes on a level place in 1 line with the shoe side up. 2) Pull pin-side master link (13) and bushing- side master link (14) together and set them to each other by the mating faces. 3) Place and fit the shoes to the mating surface of the links.
4) Check that master bolt (15) can be tightened easily with the fingers, then connect the links with the master bolt (15). 2 Master bolt: Lubricant containing molybdenum disulfide (LM-P) 3 Master bolt (Master link) Single shoe: Initial torque: 343 ± 39 Nm {35 ± 4 kgm} Retightening angle: 180° Swamp shoe: Initial torque: 490 ± 49 Nm {50 ± 5 kgm} Retightening angle: 180° 0 - 20 0 - 20 30-168 D85EX-15 (2)