Komatsu — REMOVAL

DISASSEMBLY AND ASSEMBLY EQUALIZER BAR REMOVAL AND INSTALLATION OF EQUALIZER BAR ASSEMBLY REMOVAL k Disconnect the cable from the negative (–) ter- minal of the battery. 1. Remove engine undercover (1) and power train undercover (2). 5. Remove grease hose (8). 6. Remove lock plate (9). [*3] 2. Set a hydraulic jack under the center of the equalizer bar to raise the front part of the chassis and set stand [1] under the frame to float the front part. 7. Set jack [2] at the center of equalizer bar center pin (10). 3. Remove 2 bolts (4) and cover (5). [*1] 4. Remove lock plate (6) and side pin (7).

[*2] a If the equalizer bar hole and track frame hole are not aligned, the pin cannot be removed easily. Adjust the hanging height of the track frame properly. a Repeat steps 3 and 4 to remove the pin on the opposite side. k If the track frame assembly on the opposite side is floated before the pin is pulled out, support it on a block, etc. 30-170 D85EX-15 (2)