DISASSEMBLY AND ASSEMBLY HYDRAULIC CYLINDER ASSEMBLY 2. Assembly of piston assembly 1) Set piston ring (27) to tool U6 and turn the handle 8 – 10 times to expand the piston ring. 2) Remove piston ring (27) from tool U6 and install it to the piston. 3) Using tool U7 , shrink piston ring (27). a Take care not to damage the packings, dust seals, O-rings, etc. a Clean the all parts. After installing them, cover the piping ports and pin holes to prevent dirt from entering. 1. Head assembly 1) Assemble head assembly (7) according to the following procedure. i) Using tool U4 , press fit bushing (34). ii) Install packing (33). iii) Using tool U5 , install dust seal (32). iv) Install snap ring (31).
v) Install O-ring (29) and backup ring (30). a When installing the backup ring, warm it in water at 50 – 60°C. 4) Install wear ring (26). 3. Piston assembly Set piston rod (11) to tool U1 . 2) Fit the O-ring and install head assembly (7) or (10) to piston rod (8) or (11). D85EX-15 30-181 (2)