DISASSEMBLY AND ASSEMBLY RIPPER DISASSEMBLY AND ASSEMBLY OF RIPPER ASSEMBLY For D85EX-15 DISASSEMBLY 1. Set jacks [2] under the respective centers stand [1] of the arm and beam of the ripper assembly. k Lower the blade and apply and lock the brake securely. 6. Sling beam (6) temporarily and remove the lock bolt of the pin. 7. Remove pin (7) and beam (6). a Remove the beam on the opposite side simi- larly. 4 Beam (with 3 shanks): 1,580 kg 2. Sling link (1) temporarily and remove the lock bolt of the pin. 3. Remove pin (2) and link (1). a Remove the pin and link on the opposite side similarly. 4 Link: 56 kg 8. Remove stands [1] and set them under left and right sides of the arm. 4.
Sling lift cylinder assembly (3) temporarily and 2 disconnect hoses (4). 5. Remove the lock bolt of the pin, and then remove the pin (5). a Lower the lift cylinder assembly onto the arm, inserting a block between them. a Remove the pin on the opposite side simi- larly. D85EX-15 30-185 (2)