Komatsu — ASSEMBLY

DISASSEMBLY AND ASSEMBLY RIPPER ASSEMBLY 4. Sling lift cylinder assembly (3) and install it to arm (9). a Lower the lift cylinder assembly onto the arm, inserting a block between them. 1. Sling and install bracket (10) and secure it with 4 bolts (11) and 2 nuts (12). a Install the bracket on the opposite side simi- larly. 3 Bolt: 225 ± 25 Nm {23 ± 2.6 kgm} Nut: 225 ± 25 Nm {23 ± 2.6 kgm} 5. Insert pin (8) and tighten the lock bolt. 2. Sling arm (9) and install pin (8) to bracket (10). k When aligning the pin holes, never insert your fingers in them. a Insert pin (8) to a position to install arm (9). a Install the arm on the opposite side similarly. 6.

Remove stands [1] and set them under the cen- ter of arm (9). 3. Set stands [1] under both sides of arm (9). 7. Sling beam (6) and install it to arm (9). 8. Insert pin (7) and tighten the lock bolt. k When aligning the pin holes, never insert your fingers in them. a Install the beam on the opposite side simi- larly. D85EX-15 30-187 (2)