Komatsu — ASSEMBLY

DISASSEMBLY AND ASSEMBLY RIPPER 14. Sling link (1), align the pin holes, install pin (2), and tighten the lock bolt. k When aligning the pin holes, never insert your fingers in them. a Install the link on the opposite side similarly. 9. Set jack [2] at the center of the beam. 15. Run the engine, raise the ripper assembly, and remove stands [1] from under the arm and jack [2] from the center of the beam. 10. Connect lift cylinder hose (4). 11. Sling lift cylinder assembly (3) temporarily. 12. Run the engine and extract the piston rod to align the pin holes. k When aligning the pin holes, never insert your fingers in them. Bleeding air a Bleed air from the work equipment cylinders.

For details, see TESTING AND ADJUSTING, Bleeding air from work equipment cylinders. a Supply grease (G2-LI) to each connecting pin. 13. Install pin (5) and tighten the lock bolt. a Install the lift cylinder assembly on the oppo- site side similarly. 30-188 D85EX-15 (2)