30 Testing and adjusting SEN00679-01 Adjusting valve clearance 1 a Measuring instruments for valve clearance k Stop the machine on level ground, lower the work equipment to the ground, stop the engine, and set the parking brake lever and work equipment lock lever in the lock posi- tion. a Adjust the valve clearance under the following condition. 5. While fixing adjustment screw (3), loosen lock- nut (4). a After setting the No. 1 cylinder to the com- pression top dead center, adjust the valve clearance of the No. 1 cylinder. 6. Insert thickness gauge D in the clearance between rocker arm (5) and cross head (6) and adjust the valve clearance with adjustment screw (3).
a With the clearance gauge inserted, turn the adjustment screw to a degree that you can move the thickness gauge lightly. a Valve clearance Intake valve : 0.35 mm Exhaust valve: 0.57 mm 7. While fixing adjustment screw (3), tighten lock- nut (4). q Engine coolant temperature: Normal tem- perature 1. Remove the engine hood assembly and air cleaner together. 4 Engine hood assembly: 170 kg 2. Remove all cylinder head covers (1). 3 Locknut: 45.1 – 51.0 Nm {4.6 – 5.2 kgm} a After tightening the locknut, check the valve clearance again. 3. Remove the inspection plate on the right of the radiator guard. 4.
Rotate the crankshaft forward to bring the stamped "1.6TOP" line (a) of the damper to pointer (2) and set the No. 1 cylinder to the compression top dead center. a Rotate the crankshaft with the hexagonal part at the end of the water pump drive shaft. a When the No. 1 cylinder is at the compres- sion top dead center, the rocker arm of the No. 1 cylinder can be moved by the valve clearance with the hand. If the rocker arm cannot be moved, the No. 1 cylinder is not at the compression top dead center. In this case, rotate the crankshaft one more turn. 8. After adjusting the No.
1 cylinder, rotate the crankshaft forward by 120 ° to set the stamped TOP line of each cylinder to pointer (2) accord- ing to the firing order and adjust the valve clearance. q Firing order: 1–5–3–6–2–4 9. After finishing adjustment, return the removed parts. 3 Cylinder head cover mounting bolt: 29.4 – 34.3 Nm {3.0 – 3.5 kgm} D155AX-6 11 Symbol Part No. Part name D Commercially available Thickness gauge