Komatsu D155AX-6 — MEASURING FUEL RETURN RATE AND FUEL LEAKAGE

30 Testing and adjusting SEN00679-01 4) Run the engine at high idle and stall the torque converter. After the engine speed is stabilized, measure the return rate in 1 minute with measuring cylinder J5 . a For the procedure for stalling the torque converter, see Measuring engine speed. a You may measure the return rate for 20 seconds and judge by multiplying the result by 3. a If the supply pump is not supplying fuel, the engine speed may not rise. In this case, record the engine speed, too, during the measurement. a If the return rate (spill) from the injec- tor is in the following range, it is nor- mal.

Torque converter stall speed (rpm) Limit of return rate (spill) (cc/min) 1,600 960 1,700 1,020 1,800 1,080 1,900 1,140 2,000 1.200 5) After finishing measurement, stop the engine. 4. Work after finishing measurement After finishing all measurement, remove the measuring instruments and return the removed parts. D155AX-6 21