Komatsu D155AX-6 — BLEEDING AIR FROM FUEL CIRCUIT

SEN00679-01 30 Testing and adjusting Bleeding air from fuel circuit 1 a If fuel is used up or if a fuel circuit part is re- moved and installed, bleed air from the fuel cir- cuit according to the following procedure. 1. Open the engine left side cover. 2. Remove fuel prefilter (1) and fill it with fuel. a Fill the fuel prefilter with clean fuel and take care that dirt will not enter it. a Check that the cap is fitted to part (a) (central hole) of the fuel prefilter, and then add fuel through part (b) (holes around the central hole). a After filling the fuel prefilter with fuel, remove the cap from part (a).

a If clean fuel is not available, do not remove the prefilter but fill it with the fuel by operating priming pump (4). a Do not add fuel to fuel main filter (2) from outside. 3. Install fuel prefilter (1) to the filter head. a Apply engine oil thinly over the packing on the fuel prefilter side. a After the packing of the fuel prefilter touches the sealing face of the filter head, tighten the fuel prefilter 3/4 turns. 22 D155AX-6