30 Testing and adjusting SEN00679-01 7. Start the engine with the starting motor. a The air in the high-pressure circuit is bled automatically if the engine is cranked. a If the engine does not start, there may be still air in the low-pressure circuit. In this case, repeat the above procedure from step 4. 4. Remove air bleed plug (3) of fuel main filter (2) and operate priming pump (4). a Operate the priming pump until the fuel flows out of the plug hole and install the plug. 3 Air bleed plug: 7.8 – 9.8 Nm {0.8 – 1.0 kgm} 5. Remove air bleed plug (5) of the fuel main filter and operate priming pump (4).
a Operate the priming pump until the fuel flows out of the plug hole and install the plug. 3 Air bleed plug: 7.8 – 9.8 Nm {0.8 – 1.0 kgm} 6. Loosen air bleeder (6) of the supply pump and operate priming pump (4) 90 – 100 times. a Operate the priming pump until the fuel flows out of the air bleeder and tighten the air bleeder. Then, operate the priming pump several times more until it becomes heavy. a Air bleeder: 4.9 – 6.9 kgm {0.5 – 0.7 kgm} D155AX-6 23