Komatsu D155AX-6 — MEASURING POWER TRAIN OIL PRESSURE

30 Testing and adjusting SEN00680-01 k Since the torque converter is stalled, keep pressing the brake pedal securely and keep your right foot on the decelerator pedal for safety until the work is finished. k Do not increase the engine speed to high idle during measurement. 6) After finishing measurement, remove the measuring instruments and return the removed parts. 6. Measuring transmission 1st clutch pres- sure (1ST) 1) Connect oil pressure gauge [1] of hydrau- lic tester M to oil pressure pickup plug (6). a When using an analog oil pressure gauge, use one of 5.9 MPa {60 kg/ cmІ}. 6) After finishing measurement, remove the measuring instruments and return the removed parts. 7.

Measuring transmission 2nd clutch pres- sure (2ND) 1) Connect oil pressure gauge [1] of hydrau- lic tester M to oil pressure pickup plug (7). a When using an analog oil pressure gauge, use one of 5.9 MPa {60 kg/ cmІ}. 2) Start the engine and set the parking brake lever in the FREE position. 3) Set the gearshift mode and preset range as follows with the gearshift mode selector switch and shiftup or shiftdown switch. q Gearshift mode: Manual gearshift (Ripping) q Preset range: F1-R1 4) While pressing the brake pedal, set the direction of PCCS lever in the forward position. a Keep the steering system in neutral. a Check that [F1] is displayed in the gear speed display section.

5) While running the engine at low idle, mea- sure the 1st clutch pressure. 2) Start the engine and set the parking brake lever in the FREE position. 3) Set the gearshift mode and preset range as follows with the gearshift mode selector switch and shiftup or shiftdown switch. q Gearshift mode: Manual gearshift (Ripping) q Preset range: F2-R2 4) While pressing the brake pedal, set the direction of PCCS lever in the forward position. D155AX-6 7