Komatsu D155AX-6 — MEASURING POWER TRAIN OIL PRESSURE

SEN00680-01 30 Testing and adjusting a Keep the steering system in neutral. a Check that [F2] is displayed in the gear speed display section. 5) While running the engine at low idle, mea- sure the 2nd clutch pressure. k Since the torque converter is stalled, keep pressing the brake pedal securely and keep your right foot on the decelerator pedal for safety until the work is finished. k Do not increase the engine speed to high idle during measurement. Manual gearshift (Ripping) q Preset range: F2-R2 4) While pressing the brake pedal, set the direction of PCCS lever in the forward position and shift up the gear to the 3rd gear speed with the shiftup switch.

a Keep the steering system in neutral. a Check that [F3] is displayed in the gear speed display section. 5) While running the engine at low idle, mea- sure the 3rd clutch pressure. k Since the torque converter is stalled, keep pressing the brake pedal securely and keep your right foot on the decelerator pedal for safety until the work is finished. 6) After finishing measurement, remove the measuring instruments and return the removed parts. k Do not increase the engine speed to high idle during measurement. 8. Measuring transmission 3rd clutch pres- sure (3RD) 1) Connect oil pressure gauge [1] of hydrau- lic tester M to oil pressure pickup plug (8).

a When using an analog oil pressure gauge, use one of 5.9 MPa {60 kg/ cmІ}. 6) After finishing measurement, remove the measuring instruments and return the removed parts. 2) Start the engine and set the parking brake lever in the FREE position. 3) Set the gearshift mode and preset range as follows with the gearshift mode selector switch and shiftup or shiftdown switch. q Gearshift mode: 8 D155AX-6