SEN00680-01 30 Testing and adjusting 2. Adjusting brake pedal pressing effort a While brake pedal (1) is released, adjust installed dimension (d) of return spring (5). 1) Loosen nut (8). 2) Turn double nut (7) to adjust the brake pedal pressing effort. a Turn the 2 nuts together. Do not loosen them from each other. q Adjustment dimension (d) of rod (Installed dimension of return spring): 92 ± 0.5 mm q Assembly dimension (e) of rod: 127 mm 3. Adjusting brake limit switch 1) Press brake pedal (1). When the brake pedal potentiometer voltage is in the fol- lowing range, fix the brake pedal. q Brake pedal voltage:
3,940 – 4,150 mV 2) Adjust the installed position of brake limit switch (6) so that it will be turned ON at this position. q Backup brake active Sw ON 3) After adjusting, return the brake pedal slowly and check that brake limit switch (6) is turned OFF in the voltage range shown in 1). q Backup brake active Sw OFF 4. Measuring brake pedal pressing force 1) Operate the brake pedal with the foot and check that it moves smoothly. 2) Using push-pull scale N , measure the pressing force to start operation of the brake. q Pressing force to start operation: 49 N {5 kg} 3) Using push-pull scale N, measure the pressing force at the stroke end of the brake pedal. q Pressing force at stroke end:
461 N {47 kg} 5. Work after finishing adjustment After finishing adjustment, return the removed parts. 14 D155AX-6