30 Testing and adjusting SEN00680-01 Adjusting parking brake lever 1 k Stop the machine on level ground, lower the work equipment to the ground, stop the engine, and set the parking brake lever and work equipment lock lever in the LOCK position. a Tighten the locknut of the rod securely and bend the cotter pin securely. a When adjusting the parking brake lever, remove the battery cover. q Brake oil pressure (At high idle) 4 Battery cover: 65 kg 1. Assembly and installation of lever assem- bly 1) Assemble lever assembly (1) and adjust the operation of limit switch (2). q Lever raising position: OFF, lowering position: ON q Limit switch operation stroke: 2.8 mm 2) Install lever assembly (1).
2. Checking brake oil pressure Run the engine and check that the brake oil pressure is as follows when parking brake lever (3) is set in the FREE position and LOCK position. a For the method of measuring the brake oil pressure, see Measuring power train oil pressure. D155AX-6 15 Parking brake lever Oil pressure FREE position 2.75 ± 0.29 MPa {28.0 ± 3.0 kg/cm²} LOCK position 0 MPa {0 kg/cm²}