Komatsu D155AX-6 — EMERGENCY ESCAPE METHOD WHEN POWER TRAIN HAS TROUBLE

SEN00680-01 30 Testing and adjusting 4) Start the engine and set the parking brake lever in the FREE position. 5) Operate switch assembly [1] and move the machine to a safe place. a The gear speed switch is so made that the switch on the lower gear speed will be operated first. 2) Install volume pump [3] of pump assembly P2 to the outside of the operator's cab. 3) Remove the fuel tank undercover and dis- connect supply hose (3) of the pin puller solenoid valve. 6) After moving the machine, remove the instruments used and return the removed parts. a Check that the seal at the joint of con- nector PL1 is not projected or removed and then tighten the screws to the specified torque.

3 Screw of connector PL1 : 2.83 ± 0.28 Nm {0.288 ± 0.028 kgm} 2. Escape method with brake releasing device (Using P2) a If the engine cannot be started and the parking brake cannot be released, escape according to the following procedure. 1) Assemble pump assembly P2 . 4) Connect end hose [4] of pump assembly P2 to the hose side. a Since the hose on the machine side is face seal type, use a nipple of face seal type on the pump assembly P2 side. a Stop the solenoid valve side with a cap nut, etc. Cap nut: 02789-00315 5) Turn the starting switch ON and set the parking brake lever in the FREE position. 18 D155AX-6