SEN00680-01 30 Testing and adjusting Adjusting idler clearance 1 a If the idler runs out or tilts because of wear of the right and left side guide plates or upper and lower guide plates, and guide plate, adjust according to the following procedure. 2. Adjusting in vertical direction 1) Measure clearance (b) between guide plates (5) and (6) at 2 places. 2) The idler cannot be adjusted vertically. If clearance (b) is more than 8 mm, replace the upper and lower guide plates (5), (6), (7) and (8) with new ones. a Guide plates (5), (7) and (8) are welded. 3) After finishing measurement, return the removed parts.
k Stop the machine on level ground, lower the work equipment to the ground, stop the engine, and set the parking brake lever and work equipment lock lever in the LOCK position. 1. Adjusting in lateral direction 1) Drive the machine for 1 – 2 m on a level place, then remove 2 covers (1). 2) Measure clearance (a) between the track frame and right and left guide plates (2) at 2 places. 3) If clearance (a) is more than 4 mm, remove bolt (3) and reduce shims (4). q Standard clearance (a) on each side: 0.5 – 1.0 mm a Do not loosen the bolt more than 3 turns. a This part can be adjusted to 6 mm on each side. 4) After finishing measurement, return the removed parts. 20 D155AX-6