Komatsu D155AX-6 — TESTING AND ADJUSTING TRACK SHOE TENSION

30 Testing and adjusting SEN00680-01 Testing and adjusting track shoe tension 1 k Stop the machine on level ground, lower the work equipment to the ground, stop the engine, and set the parking brake lever and work equipment lock lever in the LOCK position. Testing 1. Drive the machine slowly on a level place, then stop it. a Do not apply the brake when stopping. 2. Place straight steel bar (1) between the idler and front carrier roller and measure maximum clearance (a) between the bottom of the steel bar and shoe grouser. a For the above measurement, use an L- shaped steel which will be deflected less. 4. After finishing adjustment, return the removed parts. q Standard max. clearance (a):

20 – 30 mm Adjusting a If the track shoe tension is abnormal, adjust it according to the following procedure. 1. Remove cover (2). 2. When the tension is too high Loosen plug (3) to discharge the grease. k Since the high-pressure grease may spout out, do not loosen the plug more than 1 turn. 3 Plug: 59 – 88 Nm {6 – 9 kgm} 3. When tension is low Add grease through grease fitting (4). a If the track shoe is not tensed well, drive the machine forward and in reverse slowly. D155AX-6 21