SEN00680-01 30 Testing and adjusting Measuring and adjusting work equipment and HSS oil pressure 1 a Measuring and adjusting instruments for work equipment and HSS oil pressure k Stop the machine on level ground, lower the work equipment to the ground, stop the engine, and set the parking brake lever and work equipment lock lever in the LOCK position. a When measuring and adjusting the work equipment and HSS oil pressure, remove the control valve cover. 3) Run the engine at high idle and set the blade control lever and ripper control lever in neutral and measure the unload pressure. a The work equipment lock lever may be set in the LOCK position.
k Do not operate the work equipment or steer the machine with the oil pressure gauge of 5.9 MPa {60 kg/ cmІ} installed. If you do so, the oil pressure gauge will be broken. 4 Control valve cover: 25 kg Measuring a Measure the work equipment and HSS oil pressure under the following condition. q Hydraulic oil temperature: Within operat- ing range a The unload pressure, work equipment oil pres- sure, and HSS oil pressure can be checked with the monitoring function of the service mode of the machine monitor (See 4). 1. Measuring unload pressure 1) Remove P oil pressure pickup plug (1) from the control valve.
4) After finishing measurement, remove the measuring instrument and return the removed parts. 2. Measuring work equipment oil pressure 1) Remove P oil pressure pickup plug (1) and LS oil pressure pickup plug (2) from the control valve. 2) Install nipple Q2 and connect it to oil pres- sure gauge [1] of hydraulic tester Q1 . a When using an analog oil pressure gauge, use one of 5.9 MPa {60 kg/ cmІ}. 22 D155AX-6 Symbol Part No. Part name Q 1 799-101-5002 Hydraulic tester 790-261-1204 Digital hydraulic tester 2 799-101-5220 Nipple (10 x 1.25 mm) 07002-11023 O-ring