30 Testing and adjusting SEN00680-01 2) Install nipples Q2 and connect them to oil pressure gauges [1] of hydraulic tester Q1 . a When using analog oil pressure gauges, use ones of 39.2 MPa {400 kg/cmІ}. 3. Measuring HSS oil pressure 1) Install the measuring instruments to the control valve. a Measuring points of the HSS oil pres- sure are the same as those of the work equipment oil pressure. a When using analog oil pressure gauges, use ones of 58.8 MPa {600 kg/cmІ}. 3) Start the engine and set the work equip- ment lock lever in the FREE position.
4) Run the engine at high idle, operate the blade control lever and ripper control lever to relieve each cylinder at a stroke end, and measure the work equipment relief pressure and work equipment LS relief pressure. a The work equipment relief pressure is measured on the P-stamp side and the work equipment LS relief pres- sure is measured on the LS-stamp side. 2) Start the engine, set the parking brake lever in the FREE position, and keep pressing the brake pedal. 3) Run the engine at high idle, set the PCCS lever in the right or left steering position to relief the steering circuit, and measure the HSS relief pressure and HSS LS relief pressure.
k Since the steering circuit is re- lieved, keep pressing the brake pedal securely and keep your right foot on the decelerator pedal for safety until the work is finished. a The HSS relief pressure is measured on the P-stamp side and the HSS LS relief pressure is measured on the LS-stamp side. k Do not steer the machine with the oil pressure gauge of 39.2 MPa {400 kg/cmІ} installed. If you do so, the oil pressure gauge will be broken. 5) After finishing measurement, remove the measuring instrument and return the removed parts. 4) After finishing measurement, remove the measuring instruments and return the removed parts. D155AX-6 23