Komatsu D155AX-6 — MEASURING AND ADJUSTING WORK EQUIPMENT AND HSS OIL PRESSURE

SEN00680-01 30 Testing and adjusting 4. Measuring with machine monitor 1) Turn the starting switch ON and set the machine monitor to Monitoring function of the service mode. Adjusting 1. Adjusting unload pressure a The unload pressure cannot be adjusted. q Monitoring code: 70700 Hydraulic Pump Pressure 1 a For the operating method, see Spe- cial functions of machine monitor (EMMS). 2. Adjusting work equipment oil pressure a If the work equipment oil pressure is abnormal, adjust it with work equipment LS relief valve (3) according to the follow- ing procedure. a The 5-spool valve of the single tilt specifi- cation is shown in the figure (The dual tilt machine has the 6-spool valve).

2) Start the engine and measure each oil pressure. a The measuring condition of each oil pressure is the same with 1 – 3 above. a Only the oil pressures on the P-stamp side (unload pressure, work equip- ment relief pressure, and HSS relief pressure) can be measured with the monitoring function. The oil pres- sures on the LS-stamp side (work equipment LS relief pressure and HSS LS relief pressure) cannot be measured. 1) While fixing adjustment nut (4), loosen locknut (5). 2) Adjust the pressure by rotating adjustment nut (4). a If the adjustment nut is q rotated to the right, the pressure is heightened. q rotated to the left, the pressure is lowered.

a Quantity of adjustment per turn of adjustment nut: Approx. 19.6 MPa {Approx. 200 kg/cmІ} 3) While fixing adjustment nut (4), tighten locknut (5). 3 Locknut: 39 – 49 Nm {4 – 5 kgm} 4) After finishing measurement, check the work equipment oil pressure according to the above measuring method. 24 D155AX-6