Komatsu D155AX-6 — MEASURING CONTROL CIRCUIT BASIC PRESSURE

SEN00680-01 30 Testing and adjusting Measuring control circuit basic pressure 1 a Measuring instruments for control circuit basic pressure a The control circuit basic pressure is the pres- sure lowered by the self-pressure reducing valve of the fan circuit. It is used commonly for the EPC valves of the control valve (steering, blade, and ripper), HSS circuit charge, fan pump control, and blade lift cylinder quick drop EPC valve. 4. Run the engine at high idle, set the blade con- trol lever and ripper control lever in neutral, and measure the control circuit basic pressure. a The work equipment lock lever may be set in the LOCK position.

k Stop the machine on level ground, lower the work equipment to the ground, stop the engine, and set the parking brake lever and work equipment lock lever in the LOCK position. a Measure the control circuit basic pressure under the following condition. q Hydraulic oil temperature: Within operat- ing range 1. Remove the control valve cover and discon- nect accumulator inlet hose (1). 4 Control valve cover: 25 kg 5. After finishing measurement, remove the mea- suring instrument and return the removed parts. a The control circuit basic pressure cannot be adjusted. 2. Install adapter R2 and connect the discon- nected hose again. 3.

Install nipple [1] of hydraulic tester R1 and con- nect it to oil pressure gauge [2]. a When using an analog oil pressure gauge, use one of 5.9 MPa {60 kg/cmІ}. 26 D155AX-6 Symbol Part No. Part name R 1 799-101-5002 Hydraulic tester 709-261-1204 Digital hydraulic tester 2 799-401-3200 Adapter (03)