30 Testing and adjusting SEN00680-01 Adjusting blade 1 a If the blade is removed and installed or disas- sembled and reassemble, adjust it according to the following procedure. a The above figure shows the blade of the dual tilt specification. 1. Adjusting shims for assembly 1) Adjust the shim of tilting section (1) (1 place). a After reassembling the tilting section, supply grease to it. 2 Tilting section: Grease (G2-LI) 4 mm a Adjust the shim so that the play of the ball in the axial direction will be less than 1 mm and the ball can rotate smoothly. D155AX-6 35 Adjusted point Adjusted S clearance cl tandard Stand earance thic 1 a S ee note. 4