SEN00680-01 30 Testing and adjusting 2) Adjust the shim of center section (2) (2 places). a After reassembling the center section, supply grease to it. 2. Adjusting blade tilt distance (Single tilt specification) 1) Adjust installed dimension (d) of brace (4) with the handle. 2 Center section: Grease (G2-LI) a Adjust the shim so that the play of the ball in the axial direction will be less than 1 mm and the ball can rotate smoothly. 2) Measure right and left tilt distances (e1) and (e2). 3) Adjust the shim of lifting section (3) (2 places). 3) If both tilt distances are not the same, adjust installed dimension (d) of brace (4) according to the following procedure. q e1 > e2:
Increase installed dimension (d) slightly. q e1 Decrease installed dimension (d) slightly. 36 D155AX-6 Dimen- sion blade Semi-U blade Full-U blade d 1,292 mm 1,372 mm 1,372 mm Adjusted point Adjusted clearance Standard clearance Standard shim thickness 2 b See note. 4 mm Dimen- sion blade Semi-U blade Full-U blade e1 565 mm 570 mm 583 mm e2 565 mm 570 mm 583 mm Adjusted point Adjusted clearance Standard clearance Standard shim thickness 3 c Max. 1 mm 4 mm