30 Testing and adjusting SEN00680-01 Adjusting operator's cab 1 a If the operator's cab is removed and installed or disassembled and transported and assem- bled in the field, test and adjust it according to the following procedure. 1. Measuring internal pressure of cab a Criterion Criterion: Measured value X 88.2 Pa {9 mmH 2 O} a Measurement condition q Engine speed: High idle q Fan speed: Fan 100% mode 7) Start the engine and set the machine mon- itor to Adjusting function of the service mode. a Adjustment code: 1005 (Fan 100% mode) a For the operating method, see Spe- cial functions of machine monitor (EMMS). q EXTERNAL/INTERNAL air changeover switch:
EXTERNAL position q Air conditioner fan switch: High (FULL) 1) Prepare a transparent vinyl hose. q Outside diameter: 6 mm, Length: 3,000 mm 2) Secure the inside end of the hose to the top of the seatback with a tape. 3) Remove 1 bolt (1) under the left console box. Pass the other end of the hose through the bolt hole and take it out of the top of battery cover (2) on the left side of the cab. 8) Run the engine at high idle and measure water level difference (c) in hose [1]. q (a): Inside of cab (Pressurized) q (b): Out of cab (Ambient pressure) q (c):
Measured value (Internal pres- sure of cab) a If the measured value (internal pres- sure of the cab) is lower than the standard value, check the seals of the holes for wiring harnesses and optional parts in the cab. 4) Seal the clearance between the hole of bolt (1) and hose [1] with tape (3). 5) Pour water in the hose up to about half and bend the hose in a U-shape. 6) Secure hose [1] to the outside of the cab and set the water level in the vinyl hose out of the cab to that in the cab. 2. Checking searing performance 1) Close all the openings (doors and win- dows) of the cab. 2) Splash water around the hatched part of the cab at the rate of about 19 l /min for 10 minutes.
a At this time, it is not necessary to splash pressurized water. 3) Splash water horizontally from a hose over the contact portions of seal (4) between the cab and floor frame. D155AX-6 37