SEN00680-01 30 Testing and adjusting 4) Check around the dashboard carefully for water leakage. a If water leaks, caulk the leaking part and check again. 4) Loosen the mounting bolts of damper rub- ber (6). a You can remove and install the shims without removing the mounting bolts. 5) Increase or decrease shims (7) under damper rubber (6) to adjust the height of damper rubber (6) properly. 3. Testing and adjusting door lock (damper rubber) a Close the door and check the relationship between the operator's cab and door (damper rubber portions). If there is any abnormality, adjust it. 1) Stick adhesive tape [2] to the contact face of damper rubber (6) of door (5).
a Check both sides, 2 places on each side. 2) Open and close door (5) 2 – 3 times. 3) Check the contact portions of adhesive tape [2] and operator's cab. 4. Testing and adjusting door lock (latch and striker) a Close the door and check the relationship between the operator's cab and door (latch and striker). If there is any abnor- mality, adjust it. 1) Move door (5) in the closing direction and check the engaging condition of latch (8) and striker (9). a Check quantity of misalignment (f) between center of latch (d) and center of striker (e) from the direction of A . q Normal: When the door is closed, the damper rubber comes in contact lightly (No adjustment is required). q Normal:
Quantity of misalignment (f) is 0.5 mm or less. q Abnormal: When the door is closed, the damper rubber does not come in contact or comes in contact so strongly that the adhesive tape is removed (Adjust- ment is required). 2) Tighten the mounting bolts of striker (9) temporarily. Then, open and close door (5) 2 – 3 times to align latch (8) with striker (9). 3) Check the engagement of latch (8) and striker (9). 4) Tighten the mounting bolts of striker (9) securely. 38 D155AX-6