Komatsu D155AX-6 — SPECIAL FUNCTIONS OF MACHINE MONITOR (EMMS)

SEN00681-01 30 Testing and adjusting Adjustment ID: 0005 (Brake pedal potentiometer initial correction) Adjustment ID: 0007 (Engine decelerator cutting) q This adjustment code is used to make the power train controller recognize the zero point of the brake pedal potentiometer. a After the power train controller or brake pedal potentiometer is replaced or the brake pedal linkage is disconnected and connected, be sure to carry out this adjustment once. q This adjustment code is used to stop the auto- deceleration function of the engine and check the high idle speed of the engine unit.

a The engine can be driven and tested with the auto-deceleration reset only while this adjust- ment code is selected. a Use this adjustment code for testing, adjusting, or troubleshooting when necessary. q Functions of function switches [F3]: Unused [F4]: Unused [F5]: Return to adjustment item selecting screen (ID inputting screen) [F6]: Save corrected value q Functions of function switches [F3]: Unused [F4]: Unused [F5]: Return to adjustment item selecting screen (ID inputting screen) [F6]: Unused q Operating method: 1) Check that the brake pedal is in the neu- tral position (it is not pressed at all) and keep it in that position. 2) Press [F6] and check that the alarm buzz- er sounds.

a Even if the adjustment is carried out, the displayed value does not change. a Even if this adjustment code is turned off, the correction is effective. a This adjustment code is used to make the controller recognize the zero point of the potentiometer. It is not used to adjust the braking force. q Operating method: When this adjustment code is displayed, its function is effective and the auto-deceleration function is stopped. a After this adjustment code is turned OFF, its function is ineffective. 48 D155AX-6