OPERATION OPERATIONS AND CHECKS AFTER STARTING ENGINE When starting the engine, check that the lock lever is securely at the LOCK position. If the lock lever is not locked securely and the control levers or control pedal are touched when the engine is started, the machine may move unexpectedly, and this may lead to serious personal injury . If any problems occur, turn the ignition switch to the “OFF” position. If the work equipment is operated without warming up the machine sufficiently, the response of the work equipment to the movement of the control lever will be slow, and the work equipment may not move as the operator desires, so always perform the warm-up operation.
Particularly in cold areas, be sure to perform the warm-up operation fully. BREAKING IN THE MACHINE Your Komatsu machine has been thoroughly adjusted and tested before shipment. However, operating the machine under severe conditions at the beginning can adversely affect the performance and shorten the machine life. Be sure to break-in the machine for the initial 100 hours (as indicated by the service meter). During break-in operations, follow the precautions described in this manual. Idle the engine for 5 minutes after starting it up. Avoid operation with heavy loads or at high speeds. Avoid sudden starts, sudden acceleration, sudden steering and sudden stops except in cases of emergency.
There are two types of warming-up operation: warming up the engine and warming up the hydraulic equipment. In addition, depending on the environment, the method of carrying out the warming-up operation may differ, so carry out the warming-up operation according to the items given in the appropriate section. When only the engine is warmed up, the hydraulic equipment is not warmed up, so always carry out the warming-up operation for the hydraulic equipment separately from the warming-up operation for the engine. Warming up the hydraulic equipment thoroughly ensures that the hydraulic oil is warmed up and that warm hydraulic oil circulates in all the control circuits.
WARMING UP ENGINE Do not accelerate the engine suddenly until the warming-up operation has been completed. Do not run the engine at low idling or high idling under no load for more than 20 minutes. This will have an adverse effect on the environment, and will also have an adverse effect on the internal structure of the engine. If it is necessary to run the engine at idling for more than 20 minutes, apply a load from time to time or run at a mid-range speed. After the engine starts, do not start operating the machine immediately. First, carry out the following operations and checks. 1.
This machine is equipped with an automatic engine warming-up system, so if the engine water temperature is below 30 o C (86 o F) after the engine is started, the engine warming-up operation starts automatically. When the engine automatic warming-up operation starts, the engine speed is maintained at a speed higher than the normal low idling speed. If the engine water temperature goes above 30 o C (86 o F) or if the warming-up operation has been continued for more than 10 minutes, the automatic warming-up operation is cancelled and the engine speed drops to the normal low idling speed. PC300LC/HD-7E0 2-89