Komatsu — WARMING UP HYDRAULIC EQUIPMENT

OPERATION WARMING UP HYDRAULIC EQUIPMENT Before carrying out the warming-up operation for the hydraulic equipment, turn the swing lock switch ON, check on the monitor that the swing lock is actuated, then start the warming-up operation. When warming up the hydraulic equipment, check to be sure there is no person or obstacle in the surrounding area, then sound the horn and start the operation. Carry out the warming-up operation for the hydraulic equipment until the hydraulic oil temperature monitor displays green.

The warming-up operation for the hydraulic equipment is necessary not only for the circuit between the pump and cylin- ders and between the pump and motor, but also for all the control circuits. Do not carry out the operation just for one cyl- inder or motor, or the operation just in one direction. Carry out the operation in both directions for the work equipment (boom, arm, bucket), swing, travel, and attachment (if equipped). 1. Check to be sure engine water temperature monitor (1) displays green. If it displays white, carry out additional warming up of the engine until engine water temperature monitor (1) displays green. 2.

Turn swing lock switch (2) ON and check to be sure the swing lock monitor lights up. 3. To complete the warming-up operation of the hydraulic equipment more quickly, set the working mode to P mode (heavy-duty mode). PC300LC/HD-7E0 2-91