Komatsu — BUCKET REPLACEMENT

OPERATION Remark Carry out installation in the reverse order to removal. When installing the bucket: For arm pin part (A), fit an O-ring at the position on the bucket shown in the diagram on the right. After inserting the pin, fit it into the proper groove. For link pin part (B), install the bucket with the O- ring fitted in the proper groove. 4. Install the stopper bolts and nuts for each pin, then grease the pin. Remark Lubricate with grease thoroughly until the grease comes out from the end face. When replacing the bucket, replace the dust seal if it has been damaged.

If a damaged seal is used without being replaced, sand and dirt may enter the pin portion and cause abnormal wear of the pin. 2-120 PC300LC/HD-7E0