Komatsu — LOADING AND UNLOADING A TRAILER

OPERATION TRANSPORTING THE MACHINE Before transporting the machine be sure what you are using to transport the machine is capable of supporting the weight of the machine. Be sure it is wide enough and rated for the load. LOADING AND UNLOADING A TRAILER Select the trailer to match the weight and dimensions given in See “SPECIFICATIONS” on page 4-2. Note that the value for the weight and transportation dimensions given in SPECIFICATIONS may differ according to the type of shoe or type of arm or other attachments. Always turn the auto deceleration switch OFF (cancel) during loading and unloading operations. If the auto deceleration switch is left ON, the machine may suddenly start moving.

Always drive the machine at low speed when loading or unloading the machine on a trailer. Do not operate the travel speed selector switch. Run the engine at low idle, set to low speed, and operate the machine slowly when loading or unload- ing. Do not load or unload the machine during the automatic warm up operation. If the automatic warm up operation is canceled during the loading or unloading operation, the speed will suddenly change. Use ramps with ample width, length, thickness, and strength and install them at a maximum slope of 15є. When using piled soil, compact the piled soil fully and take action to prevent the slope face from collapsing.

To prevent the machine from slipping on the ramps, remove all mud and dirt from the machine tracks before starting to load. Be sure that the ramp surface is clean and free of water, snow, ice, grease, or oil. Never correct your steering on the ramps. There is danger that the machine may turn over. If necessary, drive off the ramps, correct the direction, then enter the ramps again. When on the ramps, do not operate any levers except the travel lever. The center of gravity of the machine will change suddenly at the joint between the ramps and the track or trailer, and there is danger of the machine losing its balance. Travel slowly over this point.

The trailer is unstable, so pull in the work equipment and swing slowly when swinging the upper struc- ture on the trailer . PC300LC/HD-7E0 2-121